What are the installation, lubrication and maintenance work of the precision reducer?


Release time:

2021-12-15

When the equipment is running, do not hit it with a hammer or similar items to prevent damage to the bearings or gears due to excessive axial or radial force. We must tighten the bolts of these equipment before tightening the bolts.

When the equipment is running, do not hit it with a hammer or similar items to prevent damage to the bearings or gears due to excessive axial or radial force. We must tighten the bolts of these equipment before tightening the bolts. In front of the equipment, the electric motor is connected to the control system input shaft, positioning boss and planetary reducer through a network connection. Use gasoline or zinc sodium water to wipe different parts of the anti-rust oil. The purpose is to ensure the tightness of the network connection and the flexibility of work, and to prevent unnecessary losses.  

Before connecting the motor and reducer, the keyway shaft and fastening bolts of the motor should not be straight. In order to ensure uniform force, first tighten the equipment bolts in any restraint position, but do not tighten them, and then use four equipment bolts to tighten the other two opposite positions of the equipment bolts one by one. After all, tighten the fastening bolts. The material of all fastening bolts needs to be fixed according to the marked fixing torque analysis data information and checked with a torque wrench.  

 

The correct equipment between the gearbox and the mechanical equipment is the same as the correct equipment between the gearbox and the drive motor. 

 

The key is to ensure that the gearbox output shaft and the drive part of the shaft are shared.  

Lubrication and maintenance of reducer: 

 

Before putting into use, put the required type and value of grease into the reducer. 

 

Before operation, inject an appropriate amount of lubricating oil into the reducer to reduce the viscosity of the lubricating oil and the following list of problems selected by the company based on related research. The reducer usually needs to be equipped with an oil injection hole and an oil drain plug. Therefore, the direction of development of the relevant equipment must be specified when ordering the reducer. 

 

Key words:


Previous Page

Next Page

Previous Page:

Next page: